SW2 Switch, Quad Bidirectional Switch

SW2 Switch, Quad Bidirectional Switch

$155 ($124 + VAT)

The SW2 is a quad bidirectional switch in Eurorack format with manual or CV control over the switches.

It can be CV controlled well above 100 kHz which opens up for interesting wave shaping of audio signals. SWT, switched wave transformation.

The SW2 is the same module as the SW1 but with a different front panel.

In stock

Description

Bidirectional switch means that signals can flow in both directions through the switch. You can send signals in on 1 and out on 1G or 1R. Or you can send signals in on 1G and 1R and 1 will be the output. The same applies to channel 2, 3 and 4.

The switches can be latched in pairs. The layout is for ergonomics when switching stereo buses.

Each switch can be CV controlled up to well above 100 kHz. This opens for interesting wave shaping as you can switch out a piece of a single cycle of an audio rate signal and replace it with something else. SWT, switched wave transformation. Or change/swap places of your modules in your chain at up to high or above audio rate.

Device specs

Module size: 8 hp wide, 25 mm deep with power connector.

Input impedance CV: 100 kohm

Power requirements: +12V. Max power consumption 30 mA.

                               -12V. Max power consumption 5 mA.

Connect the power cable with the red stripe (-12V) down.

The unit is protected for reverse power.

Manual (SW2)

Manual (SW2)

Download: SW2 Switch manual (pdf)

Videos (SW2)

Videos (SW2)