AV3, Attenuverter, Mixer, Comparator
$94 ($75 + VAT)
The AV3 is a dual attenuverter, voltage source, mixer and comparator combined. You can use the functions by them selves or combined.
The combination of simple functions makes this a very useful module to have in your toolbox.
It can be used for control signals or for audio.
The bandwidth of the AV3 is more than 300 kHz. This makes it suitable for clean audio operation like mixing or subtracting signals without adding any frequency dependent phase shift.
The AV3 is the same module as the AV2 but with a different front panel.
In stock
Description
AV3 is a Eurorack format dual attenuverter with some extra functions. It can be used as a utility unit for control voltages or as an audio unit.
It has besides the two attenuverter in and outputs a suming mixer output with an attenuverter. This sums the signals after the A and B attenuverters.
When nothing is connected to A or B they can be used as voltage sources. You can set the output to +/- 5V DC. This way you can run an LFO trough A, use B as a voltage offset and get the sum out on SUM, if you for instance need a unipolar signal.
The output A>B is a comparator output with a volume control. This can be used as a logical signal or as audio. The signal on A>B depends on whats coming out from A and B.
Next to each knob is a green/red LED showing the level and polarity of the output signal.
The green/red LED next to the A>B knob shows the signal before the red volume knob so you can se how the comparator reacts before turning up the volume.
Device specs
Module size: 5 hp wide, 30 mm deep with power cable connected.
Input impedance : 50 kohm
Output impedance: 1 kohm
Power requirements: +/-12V. Max power consumption 45 mA.
The bandwidth of the module is more than 300 kHz.
Connect the power cable with the red stripe down towards the -12V marking.
The unit is protected for reverse power.